通信原理论文(中英文版)
更新时间:2023-11-11 23:42:01 阅读量: 教育文库 文档下载
- 关于通信原理的论文推荐度:
- 相关推荐
Optimized Pulse Shaping for Intra-channel
Nonlinearities Mitigation in a 10 Gbaud Dual-Polarization 16-QAM System
Beno?t Chatelain1, Charles Laperle2, Kim Roberts2, Xian Xu1, Mathieu Chagnon1, Andrzej Borowiec2, Fran?ois Gagnon3, John C. Cartledge4, and David V. Plant1
1McGill University, Montreal, Quebec, Canada, H3A 2A7 2Ciena Corporation, Ottawa, Ontario, Canada, K2H 8E9
3école de technologie supérieure, Montreal, Quebec, Canada, H3C 1K3 4Queen’s University, Kingston, Ontario, Canada, K7L
3N6 Email: benoit.chatelain@mail.mcgill.ca
Abstract: An optimized pulse shape is shown to reduce intra-channel nonlinear effects in a 10 Gbaud dual-polarization 16-QAM EDFA-amplified system without optical dispersion compensation.
OCIS codes: (060.2330) Fiber optics communications; (060.4080) Modulation
1. Introduction
Intra-channel nonlinear distortion is an important source of signal degradation in optical
communication systems using advanced modulation formats such as quadrature amplitude modulation (QAM). Its main impact is to reduce the maximal power that can be launched into the fiber, thereby limiting optical signal-to-noise ratio (OSNR) levels at the receiver, reducing system margins and reducing the maximum propagation distance that can be achieved. In this paper, the nonlinear tolerance of an optimized pulse and a root-raised cosine (RRC) pulse is compared in terms of bit error rate (BER) performance, for varying propagation distances and launch powers. Experimental results show that the optimized pulse considerably reduces intra-channel nonlinear effects in a long haul, 10 Gbaud dual-polarization (DP) 16-QAM system relying on erbium-doped fiber amplifiers (EDFAs) and G.652 fiber (no optical dispersion compensation).
The improved nonlinear tolerance of the return-to-zero (RZ) pulse shape was recently highlighted in [1], for a 112 Gb/s DP-quadrature phase shift keying (QPSK) system without optical dispersion compensation. Comparing the RZ pulse to the non return-to-zero (NRZ) pulse, the authors reported an increase in single channel maximum propagation distance of 18%. However, the improved nonlinear tolerance achieved using the RZ pulse comes at the expense of increased spectral content. For instance, the bandwidth of a 50% RZ pulse is twice the bandwidth of the NRZ pulse or the RRC pulse with a roll-off factor (α) of 1. The use of a RZ pulse thus reduces spectral efficiency by a factor of two, and for a system using digital signal processing at the transmitter and receiver, at the Nyquist rate, it doubles the required bandwidth and sampling frequency of the digital-to-analog converters (DACs) and analog-to-digital converters (ADCs).
(a)
(b)
Figure 1. Impulse (a) and frequency (b) responses of the RRC and optimized pulses.
In comparison to the RRC pulse, the optimized pulse shape presented in [2] was shown to improve
the nonlinear performance of DP-QPSK systems without optical dispersion compensation and to increase the maximum transmission distance by as much as 22%. The specialized pulse was obtained by numerical optimization, with the primary objective formulated to reduce its width, but constrained to have a bandwidth equal to the bandwidth of a NRZ or RRC pulse (α = 1). Therefore, the optimized pulse can be used without penalizing spectral efficiency and without using higher speed DACs and ADCs. Fig. 1 exhibits the time and frequency characteristics of the optimized and RRC pulses. It can be seen that the optimized pulse is narrower than the RRC pulse with α = 1, and that its first-null bandwidth is equal to the baud rate. It is also apparent that the reduced width of the optimized pulse translates in higher energy content for frequencies between 6 GHz and 10 GHz. Through dispersion, the higher energy frequencycomponents produce a propagating pulse and a propagating waveform that is more broadened, with lower peak power excursions. Since intra-channel nonlinear distortion is proportional to peak power, the optimized pulse makes the system more tolerant to nonlinear effects. In this work and as in [2?5], the RRC pulse is used as the reference pulse for its ability to minimize pulse-induced intersymbol interference (ISI) and to minimize out-of-band power.
2. Experimental Setup
Fig. 2 illustrates the experimental setup. The symbol sources consist of random symbol sequences of length 214 and were followed by pulse shaping finite impulse response (FIR) filters. DACs with 6-bit resolution drive the in-phase-quadrature (I-Q) modulators associated with the two polarizations. The emitting wavelength was set to 1547.715 nm. A polarization scrambler (PS) was inserted after the polarization beam combiner (PBC) in order to randomly rotate the polarization state. A fiber link consisting of 15 spans of 80 km G.652 fiber was used, together with EDFAs at each span. At the receiver, a noise source was used to adjust the OSNR. The optical spectrum analyzer (OSA) served the purposes of measuring the OSNR. A coherent front-end integrates polarization beam splitters, optical hybrids, a local oscillator and photodetectors [6]. It provides four signals corresponding to the in-phase and quadrature components of the two polarizations. These baseband signals were sampled using a 50 GSa/s oscilloscope with 8-bit ADCs and post-processed in a personal computer. The linewidth of the transmitter and receiver lasers was 100 kHz, and their frequency offset was below 200 MHz. The same clock reference was used for the DACs and ADCs. The receiver signal processing functions include matched filtering and chromatic dispersion compensation (CD-1) by FIR filters, polarization recovery by a 13-tap fractionally spaced (T/2) butterfly equalizer (EQ), carrier offset removal and carrier phase recovery by a second order phase lock loop (PLL) and finally, detection. The constant modulus algorithm (CMA) is used for the equalizer coefficients pre-convergence. Once the signal is recovered, the system switches to a decision-directed modulus algorithm (DDMA) [7]. Two symbol pattern periods, totaling 215 symbols for each polarization, were used to produce BER statistics.
In what follows, the system performance is studied using either the RRC pulse or the optimized pulse presented in Fig. 1 as transmit FIR filters and receive matched filters.
Figure 2. Experimental setup.
3. Results and Discussion
Fig. 3 displays the electrical eye diagrams of the signal in-phase component taken at the transmitter, after the FIR pulse shaping filter. The inner eye openings of the optimized 16-QAM sequence eye diagram are reduced compare to those in the eye diagram obtained using the RRC pulse, indicating, as mentioned in [2], that the optimized pulse may be more sensitive to timing jitter. Fig. 3 (b) further shows that the eye diagram obtained with the optimized pulse is very similar to the eye diagram that would be obtained using an RZ pulse, and that the optimized pulse sequence returns close to a zero level between each symbol period. Since the RRC and the optimized pulses are designed to be used as matched filter, it is expected to visualize on the eye diagrams at the transmitter a certain amount of ISI. The RRC and optimized pulses produce a filtered sequence with zero pulse-induced ISI only at the receiver, after matched filtering.
Fig. 4 (a) reports the measured BER in a back-to-back configuration for a system using RRC filters and for a system using optimized filters. The linear performance of the RRC and optimized pulses is very similar and for the considered range of OSNR, the minimal and maximal penalty is 2.5 dB and 6.5 dB, respectively. Fig. 4 (b) and (c) show propagation results for 800 km and for 1200 km. At 800 km and considering a BER threshold of 8×10-3, the optimized pulse reduces the OSNR penalty by 0.6 dB and 2.8 dB, for launch powers of –2 dBm and 0 dBm, respectively. At 1200 km and for a launch power of –2 dBm an improvement of 1.2 dB is observed. At 1200 km and for a launch power of 0 dBm, the system with optimized pulse shaping almost reaches the BER threshold, while the system using RRC pulses is limited to a BER of 1.8×10-2. At this level, the optimized pulse outperforms the RRC pulse by 4.3 dB. It should be noted that the introduction of soft-decision forward error correction (FEC) [8] would be required to be able to operate at the considered BER threshold.
正在阅读:
通信原理论文(中英文版)11-11
化工原理精选例题02-04
氧化还原反应教案05-31
心理素质测试08-15
2015同济大学经管院考研经验06-06
赠言大全_百分网02-06
新一代大学英语视听说教程2 答案05-11
103规约细则05-16
怎样对美术课进行点评12-09
- exercise2
- 铅锌矿详查地质设计 - 图文
- 厨余垃圾、餐厨垃圾堆肥系统设计方案
- 陈明珠开题报告
- 化工原理精选例题
- 政府形象宣传册营销案例
- 小学一至三年级语文阅读专项练习题
- 2014.民诉 期末考试 复习题
- 巅峰智业 - 做好顶层设计对建设城市的重要意义
- (三起)冀教版三年级英语上册Unit4 Lesson24练习题及答案
- 2017年实心轮胎现状及发展趋势分析(目录)
- 基于GIS的农用地定级技术研究定稿
- 2017-2022年中国医疗保健市场调查与市场前景预测报告(目录) - 图文
- 作业
- OFDM技术仿真(MATLAB代码) - 图文
- Android工程师笔试题及答案
- 生命密码联合密码
- 空间地上权若干法律问题探究
- 江苏学业水平测试《机械基础》模拟试题
- 选课走班实施方案
- 中英文版
- 原理
- 通信
- 论文
- 社区护理学复习题及答案
- 建筑经济管理人才培养方案2012.10.20
- 路床6%灰土试验段施工成果总结
- Tecplot画等值线的操作步骤详细介绍(第一部分)
- 教育对我国国民经济增长的影响
- 各类监控化学品目录
- 第4章习题参考解答
- 园林绿化工技师试题
- 建筑桩基技术规范(JGJ94-94)
- 网络故障排除手册及常用工具
- 课堂习题(答案)
- 中等职业学校“双师型”教师评定职业资格证书一览表
- 烟草栽培试题
- 译林版六下五六单元按要求改写句子专项
- (完整版)商务英语指导书毕业设计
- 反分裂斗争再教育整改措施
- 青少年时间管理倾向量表
- 低年级语文单元整体教学中识字教学的策略初探
- 砖瓦企业专项整治工作方案
- 国光E路通专用终端设置操作说明书--陕西建行 - 图文